Help connecting Cisco 5508 WLC to Cisco 2960 switch

[Clay Plaga]

I have a Cisco 5508 wireless controller that I'm using on my test Network. I'm having a connectivity problem with the 5508. I have completed the initial configuration on the 5508. My Management Port is Port 1 on the 5508.  I'm using a CAT5 SFP adapter on Port 1 of the 5508 with an IP address of 192.168.5.250. The other end of the cable is connected to a 2960 PoE switch on gigabitethernet0/2. Both interfaces are up, but I can not ping the 5508. I am pinging the 5508(192.168.5.250) from the domain controller(192.168.5.7). What configuration do I need to make so I can connect to the 5508? I have included 2 screenshots.

Thank you.

[patoberli · Accepted solution]

Can you please show the port configuration of the 2960?
Normally it should be similar to this:
int g0/2
switchport mode trunk
switchport trunk native vlan 1 ! assuming vlan1 is your management vlan
end

[pythgrayo]

I have same problem with my switch 2960 and wcl 5508

i changed config but problem not resolve

can u help me ?

thks