How to check LAP radio power level on WLC via CLI ?

[DuJin0509]

Hello everyone,

A customer complained the his WIFI access quality is bad , Our 3rd line engineer suppose the AP power is low , and the TPC settings for AP B281-01 on both the radios have been set to Global, what is meaning of  "Global" ?

How can I check radio power level on WLC via CLI please ?

Thank you .

[Scott Fella]

You can issue a show advanced 802.11a txpower or for 2.4ghz, use 802.11b

-Scott

*** Please rate helpful posts ***

[DuJin0509]

thank you for your answer.

[Leo Laohoo · Accepted solution]

How can I check radio power level on WLC via CLI please ?

Several methods of doing this:  

1.  sh ap config <802.11a/802.11b> summary 

2.  grep include "Power Level" "sh ap auto-rf <802.11a/802.11b> <AP name>".

[DuJin0509]

Thank you Leo, but what is the meaning of "Global" , could you please explain it to me ?

[Leo Laohoo]

Thank you Leo, but what is the meaning of "Global"

Global means "all the APs" will get the same configuration item from the controller.  Tx Power & DCA are two settings which are set to automatic, "Global" channel assignment & "Global" power control, as well as user can individually set the APs Tx Power & channel assignment.

[DuJin0509]

Thank you .