How to configure a 1131 set as WGB to auth via WPA2?

[cottert]

The guides I checked only describe: #1 -  a 1231 using WEP and #2 only provides an example for WPA-PSK? I want to use an SSID configured on the WLC shown below. Is there a guide explaining the config for WPA2?

thanks.

Tom

Security

802.11 Authentication:........................ Open System

Static WEP Keys............................... Disabled

802.1X........................................ Disabled

Wi-Fi Protected Access (WPA/WPA2)............. Enabled

WPA (SSN IE)............................... Disabled

WPA2 (RSN IE).............................. Enabled

TKIP Cipher............................. Enabled

AES Cipher.............................. Enabled

Auth Key Management

802.1x.................................. Enabled

PSK..................................... Disabled

CCKM.................................... Enabled

1. Workgroup Bridges in a Cisco Unified Wireless Network Configuration Example http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml

2. Configuring Repeater and Standby Access Points and Workgroup Bridge Mode

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43hot.pdf

[Federico Ziliotto]

Hello,

The following link contains further details for authenticating the WGB via EAP-TLS:
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00809637dd.shtml

Hope this helps,

Fede

--
If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.