Wireless

Hello,we have a few access points connected to a 2960 cisco switch which in turns connects to 3560 Layer 3 switch there are two vlans (vlan 1 (192.168.10.0) and vlan2 (192.168.20.0) )..currently all users (including wireless) users are on vlan 1  whi...

HiCan anybody suggest, wether Heat Maps can be generated via WCS BAse license only or do i need WCS with Plus lic and Location Services Appliance.RegardsAtif

On the ASA if I have an inbound static mapping (public address, private address), does that same NAT apply for outbound traffic automatically or will it use my NAT pool?

We have WLC 4402 and LWAP 1510In access control list menu, all needed rule added and the last rule deny any to anyWe use Ethernet bridging on LWAP and some clients connect with wire network that associated with Ethernet bridge LWAP, Now when deny rul...

We are experiencing a high amount of retries in one direction between two 1310 bridges with external yagi antennas.  What would this indicate?  Here is a copy of the linktest:POOR (102% retries)  Time   Strength(dBm)   SNR      SNR          Retries  ...

Hi,I have new 881W router, the wired portion works like a charm, the wireless part not quite..When using Cisco Config Pro to access wireless part of it. it suppose to open a browser so i can continue configuring wireless part. Unfortunately, when i c...

Hi forumers'I would like to restrict web authentication user to access to my other network devices. web authentication user only cna goto internet, that's all. according to my attachment, am i writing the right ACL syntax and apply this at the web au...

HI,I am using AP 1231G accesspoint (CAPWAPP mode ) in my network, last few days i am observing  resets in my dot11radio interfaces . Can any one tell me the reason .I am attaching the show logging from the AP.Thank You ! Angus

HI,Is it possible for me to plug in and turn on on-board redundant power supply for a 4402 WLC that is already online and in production without any disruption to Wireless users and APs attached to that same controller?Thanks, Pat.

Could someone take a look at the output from this debug? I attached a notepad of the debug output of a laptop roaming between access-points. At around "Wed Aug 17 07:54:26 2011" on the debug I see what appears to a be client disconnecting and request...

Good Afternoon,I have arrived on a site with three Cisco 1131AG Wireless Access Points WITHOUT a controller.I want to run these in Autonomous Mode so I can use them in a more "small business" way, that is with one AP being the Root Access point with ...

Wireless Control System 7.x Figure 10-19 Configure > Ethernet SwitchesI'm only doing wireless 3502 APs, do I get anything for adding all the switches on my campus into the WCS? Is it just for tracking rogus APs? I'm not clearly understanding why I sh...