The guides I checked only describe: #1 - a 1231 using WEP and #2 only provides an example for WPA-PSK? I want to use an SSID configured on the WLC shown below. Is there a guide explaining the config for WPA2?
thanks.
Tom
Security
802.11 Authentication:........................ Open System
Static WEP Keys............................... Disabled
802.1X........................................ Disabled
Wi-Fi Protected Access (WPA/WPA2)............. Enabled
WPA (SSN IE)............................... Disabled
WPA2 (RSN IE).............................. Enabled
TKIP Cipher............................. Enabled
AES Cipher.............................. Enabled
Auth Key Management
802.1x.................................. Enabled
PSK..................................... Disabled
CCKM.................................... Enabled
1. Workgroup Bridges in a Cisco Unified Wireless Network Configuration Example http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080905cea.shtml
2. Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43hot.pdf