06-25-2014 08:11 AM - edited 07-05-2021 01:05 AM
Hi,
I have an exisitng 1142N ap and WISM1 WLAN setup and would like to get the 1142N associated with a newly installed 5706 WLAN controller.
I have moved an 1142 to the same vlan and can ping it from the 5760 but it is not attempting to join the 5760.
Any ideas ?
Thanks in advance,
Dermot
Solved! Go to Solution.
09-07-2014 02:24 PM
if 1142 go & register to your WiSM1 then you can do the below.
Go to WiSM-WLC GUI & select the 1142 AP. Under high availability tab configure your 5760 name & IP address as primary controller. Put WISM name & IP as secondary controller. Then see whether it goes & register to your 5760
HTH
Rasika
**** Pls rate all useful responses ****
09-07-2014 02:24 PM
if 1142 go & register to your WiSM1 then you can do the below.
Go to WiSM-WLC GUI & select the 1142 AP. Under high availability tab configure your 5760 name & IP address as primary controller. Put WISM name & IP as secondary controller. Then see whether it goes & register to your 5760
HTH
Rasika
**** Pls rate all useful responses ****
09-08-2014 01:49 AM
I had tried this myself and it worked but thanks for your response :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide