How to see RSSI on WLC? Trying to adjust directional antennas for aironet bridge mode.

[mikenewcomb]

Hello all, I'm installing a pair of 1572 aironets in bridge mode to connect a remote workshop to my network. Bridge only, no clients will connect. When adjusting the directional antennas, how do I see signal strength in real time to get the best connection?

TIA

[Rasika Nayanajith]

if they are in "Root Bridge" & "Non Root Bridge" mode, then you can use "show dot11 association <mac_addr>" CLI output to verify RSSI/SNR

HTH

Rasika

*** Pls rate all useful responses ***

[mikenewcomb]

I tried that but it was not accepted on either AP or the WLC CLI. Maybe an different code or something?