HTML GUI fails after Upgrade

[aebert]

After Upgrading my AP to c1100-k9w7-mx.123-2.JA' with the command 'ARCHIVE tar /xtract tftp://192.168.1.11/c1100-k9w7-tar.123-2.JA.tar flash:' I'm not able to access the html GUI although it is updated...

Any Suggestions?

[davis]

FWIW, I had the same problem this morning.

After adding a USERNAME account thru the CLI

and rebooting to upgrade to the 802.11g card,

the GUI began working. I'm not sure if the

USERNAME or just the reboot fixed it??

HTH

mike

[dixho]

I suggest you to re-install 12.3(2)JA again by using "archive download-sw /overwrite /reload ftp://192.168.1.11/c1100-k9w7-tar.123-2.JA.tar.

I assume that you have enough room in the flash. Otherwise, you have to do a show flash: and delete all unncessary files.

[dewman03]

I was reading the release notes for 12.3(2)JA and it says that this release supports SSL (https://)

Is this enabled by default?

Does this mean that to access the gui you need to enter

https://10.0.0.1 instead of

http://10.0.0.1,.

If this were the case the GUI would seem to stop working, but thats only if it is enabled by default

just my 2 cents

[scottmac]

https has to be manually enabled (not the default).

Try turning off your pop-up blockers on your browser.

Good Luck

Scott