12-16-2010 08:26 AM - edited 07-03-2021 07:33 PM
Hello,
In a WLC 5508, i have one AP in first floor and other AP in second floor. I create two WLANS but i need to publish one in first floor and the other in second floor.
Is this posible?
Solved! Go to Solution.
12-16-2010 10:33 AM
Well Honestly , it depends on the WLC version that you are using.
In olde releases this has to be implemented using wlan override
feature where you need to go to wireless --> Access Points --> Radios --> select either 802.11b or a --> on each AP there is a blue arrow adjacent to it where you can hover over it and select configure.
In the resulting page there ssid override option that you can enable and select the SSIDs that should be broadcasted on that AP.
On the new releases this has been combined in AP groups so you configure lets say AP group for floor one and another one for floor 2 , in the first one u add the ssids that should appear on floor 1 and the list of APs in that floor.
Then you do the same in the second group.
Mohammad Aldehnee
------------------------------
Don't forget to rate answers that you find useful
12-16-2010 08:46 AM
Hi,
yes this can be done.. This feature is called AP-Grouping.. here is the configuration example to perform the same..
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml
Lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the usefull post which answered your question or was helpfull
12-16-2010 10:24 AM
Hello Surendra,
I see the configuration example, but i think that Ap Group Vlan is to publish the same ssid with diferents vlans.
But i need to publish diferent SSID per AP.
12-16-2010 10:33 AM
Well Honestly , it depends on the WLC version that you are using.
In olde releases this has to be implemented using wlan override
feature where you need to go to wireless --> Access Points --> Radios --> select either 802.11b or a --> on each AP there is a blue arrow adjacent to it where you can hover over it and select configure.
In the resulting page there ssid override option that you can enable and select the SSIDs that should be broadcasted on that AP.
On the new releases this has been combined in AP groups so you configure lets say AP group for floor one and another one for floor 2 , in the first one u add the ssids that should appear on floor 1 and the list of APs in that floor.
Then you do the same in the second group.
Mohammad Aldehnee
------------------------------
Don't forget to rate answers that you find useful
12-16-2010 12:40 PM
Thanks for the answer!
12-16-2010 05:10 PM
Even i told the same with Link!! i guess you did not go through the link correctly!!
Regards
Surendra
12-20-2010 12:03 PM
Finally i resolve the problem using Vlan Override feature clicking:
Wireless --> Access-Points --> Radios --> 802.11x -->Choose AP --> Click Configuration --> Choose Enable in Vlan Override
12-20-2010 08:50 PM
WOW!! Thats great to hear!!... n FYI.. in the newer WLC software versions.. WLAN Override is nothing but AP-Groups.. that is after 5.X and above its AP groups..
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide