In Two wism module in 6500 series how to make fail over for these four wireless lan controller

[syed baseeruddin]

Hi
In our project we configure two wism controller

In Each wism controller they are two controller

Altogather they are four controller

each wism module will support 150 APS

in our they are 210 APS of 1042 model

How can i make fail over for these four controller

But each controller in Highavailability they are only there options

1 primary
2 secondary
3 teritary

How to make these fail over for these four controller

experts please clarify confusion of these four controller

[Leo Laohoo · Accepted solution]

Depending on the firmware of the controllers, the AP must be individually configured to specify the primary/secondary controller details.   The command is: 

config ap secondary <controller name> <AP name> <controller Management IP address>
config ap primary <controller name> <AP name> <controller Management IP address>

Notice the secondary controller comes FIRST.  Make sure this is how you enter the details or the AP will shoot off to the primary controller before anyone could enter the secondary controller.

[syed baseeruddin]

Thanks Leo Laohoo,

the controller  software version 7.0.252.0 

[Leo Laohoo]

Thanks Syed. 

By the way, this thread is eerily similar to THIS thread.