Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2800
Views
5
Helpful
4
Replies

Light Weight Access Point and Tacacs authentication

Go to solution
Totardo Tobing
Level 1
Level 1

‎04-27-2012 07:34 AM - edited ‎07-03-2021 10:04 PM

Hello,

I need a help here,

My access points already joined WLC. I want to configure it so everyone who wants to log on to the access point is authenticated using tacacs authentication? How can I do this? I already search at the Configuration guide but I can't find and I can't find a command to input the tacacs server in that lightweight access points.

Can you help me of how to configure lightweight access point that already join the controller so everyone who wants to log in to it is authenticated using tacacs authentication?

Kind regards,

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Stephen Rodriguez
Cisco Employee
Cisco Employee
In response to Totardo Tobing

‎04-27-2012 07:53 AM

ahh, ok.  No, you can't do that as the AP isn't aware of TACACS. 

Out of curiosity, why would you need/want to go to the AP?  For the most part you can pull any of the show commands from the CLI of the WLC, which is TACACS aware.

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post