01-31-2018 09:42 AM - edited 07-05-2021 08:11 AM
Hi, As we know, we can see and configure many features for AP via WLC. but now I would like to logon to AP via its WLC to enter some commands. Its like using ssh or telnet to logon to AP to type some command. Can I do this? Thank you
01-31-2018 10:17 AM
Hi
Yes you can. On the AP config page on WLC you can define username and password. Then, on the advanced tap, check "Over-ride Global Credentials "
You can follow this guide:
-If I helped you somehow, please, rate it as useful.-
01-31-2018 10:56 AM
Thank you so much for your reply. I think what you are mentioning is about how to configure username and password etc for ap in WLC. Sorry I was not clear about my question.
Now username and password for AP has been configured. I wonder if we can have a page on WLC side to logon to AP, and then are able to type some command for configuring AP like we logon to AP via ssh or telnet from outside
01-31-2018 11:15 AM
01-31-2018 10:34 PM
Hi Leo,
Somehow this command doesn't work on my WLCs.
(j1c-wc-c1a) >debug ap enable <AP Name>
(j1c-wc-c1a) >debug ap command "show ip int br" <AP Name>
The WLC is 5508 running 8.2.160.0 and the AP is 3700. SSH is enabled on the APs with overriding the credentials. Is there any limitation around this command ?
Thanks,
Manish
01-31-2018 10:47 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide