01-15-2012 01:56 AM - edited 07-03-2021 09:22 PM
I have cisco LWAPP 1242 AP already joined controller but 802.11b/g shows down on the radio 0 interface. I tried to enable it but it comes with an error" Error in enabling admin status". I have resetted the AP to factory default settings and even replaced with NEW AP. Any comments would be appreciated.
01-15-2012 03:38 AM
Do you have the global 802.11bgn network enabled? It's the correct country code on the AP? Been seeing that lately. Also, console into the ap while booting up and post the output.
Thanks,
Scott Fella
Sent from my iPhone
01-15-2012 01:15 PM
Only radio 0 right?
Can you please tell us what is the domain of your WLC set for? Please post the command "sh inventory" taken from the WAP in question?
01-18-2012 06:44 AM
Issue got fixed by disabling cdp on accesspoint. Thanks for your support
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide