Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi there,Is it possible to set up an alarm on WCS each time an AP hits an user threshold ? thanks im advanced!
Hi! Will it support roaming between WLC 5508 ver. 7.0 and WLC 4402 ver. 4.2?
Hello All...We have two wlc (5508) configured Foriegn/Anchor method. Mobility tunnel is up, eping & mping were successfull. We configured external DHCP and DNS at the anchor end. web authentication (we use ISE) at L3 level was configured. But when cl...
Controller is vWLC 7.4, AP is 2600. Browser gets successfully redirected to 1.1.1.1, so DNS appears to work. However 1.1.1.1 does not respond. Wireshark in the client shows SYN frames but no response. I tried various debugs but nothing is shown on th...
I had this AP configured on a completely different subnet with a static IP in autonomous mode. I pulled the equipment out of that warehouse and now want to configure and deploy it on our normal company subnet.How do I set the AP b...
Hi all,i want to configure Cisco Aironet 1600 series as a repeater associated with non-cisco wi-fi router. I would like to ask if is that possible at all, since i have read at some forums that Cisco APs can be associated only with other Cisco APs, an...
I have two questions about my WCS / WLC that I have not been able to really get a firm understanding on. Any input would be appreciated greatly! 1- When setting up the maps, it askes about the floor height. I have not been able to figure out what tha...
Hi,How do I change 1310 Autonomous AP to a Controller based AP for 5508 WLC? Thank you.Michael.
HiI have a different models of Access-Point, but when occur electrical cut, the ap not associate againt to controller, additional lost a domain and dns. All AP have static ip address, dns and domain.I configure HARegards.
Hi everyone,On IOS 2600 AP, I tried to disable the LED but the command seems to have disappeared. On 1140 running the same 15.2 code, you use the config terminal "led" command but it's not present on the 2600.Anyone knows why ? or if there is a worka...
I am about start a project to upgrade my wireless access points. We have auite a mix of 1131, 1142, 3502 and 3602 APs. I'd like to be able to compare the capacities of these devices in terms of throughput and particularly, number of users. I am ha...
What is the difference between AP and Wireless Bridge in AP mode? Or, when to use AP like device and when Wireless Bridge in AP mode?Thanks for cooperation.Jovan M., CCNA
Hi all, I could need a little help troubleshooting some AP issue.For some reason some AP will not join the WLC. (WISMII)I have several hundrede AP online, but still a few offlineThis fails:FRH-R06-L226-UX-G#sh cdp nei gi2/0/41 detail ----------------...
Hiis it possible to setup and use 1552 AP as a standalone AP, without WLC to act as a bridge between two locations and possible to serve the clients?With 1142 (indoor) i can setup autonomouse mode, access 1142 AP over the http ad configure it without...
Hi All,Looking at the Cisco WLC you can easily track someone's MAC address depending on their AP association on the WLAN Network. Does anyone know of an application that will present these MAC Addresses in real-time? Does WCS (or Prime i think it i...
