LWAPP ios image

[vishalpatil86]

hi,

which one is LWAPP ios image for cisco 1242AG series AP?

c1240-k9w7-tar.124-10b.JA.tar

c1240-k9w7-tar.124-10b.JA3.tar

c1240-k9w7-tar.124-25d.JA.tar

[Surendra BG]

Hi,

None of them are LWAPP images.. All of them are IOS images..

LWAPP image will be having K9W8 in the image..

lemme know if this naswered your question!!

Regards

Surendra

[vishalpatil86]

hi,

is this lwapp image?

c1240-rcvk9w8-tar.123-11JX1.tar

[Surendra BG]

Yes it is

Regards

Surendra

[Surendra BG · Accepted solution]

Hi,

Here is the link which gives you list of LWAPP images

http://www.cisco.com/cisco/software/release.html?mdfid=280237322&flowid=7588&softwareid=280775090&release=12.4%2821a%29JA2&relind=AVAILABLE&rellifecycle=&reltype=latest

LWAPP image looks like this..

c1240-rcvk9w8-tar.124-21a.JA2.tar

c1240-rcvk9w8-tar.124-10b.JDA.tar

Lemme know if this answered your question!!

Regards

Surendra

[vishalpatil86]

how can i install it to an AP having autonomous image alreasy?

[dmantill · Accepted solution]

via TFTP with the archive download command

[vishalpatil86]

can u pls tell me the steps?

[Surendra BG · Accepted solution]

Hi,

Here is the link which you can use..

https://supportforums.cisco.com/docs/DOC-14960

Regards

Surendra

[Surendra BG · Accepted solution]

Hi,

Please use the below link and this will let us know the procedure to convert the LWAPP to Autonomous or Autonomous to LWAPP..

https://supportforums.cisco.com/docs/DOC-14960

Lemme know if this answered your question!!

Regards

Surendra

[vishalpatil86]

hi,

successfully loaded the lwapp. thank u.

but it is not showing the signal.

also not showing dot11radio.

help me on this

[Surendra BG · Accepted solution]

This is expected.. when this gets registered ti the WLC then you will be able to get the signal based on the WLC config!!

Lemme know if this answered your question!!

Regards

Surendra

[vishalpatil86]

it is registered with wlc,

it has taken the config of previously configured autinomous mode like IP and default gateway.

[Surendra BG · Accepted solution]

on the AP console.. issue the command "show capwap client rcb" or "show lwapp client rcb" and paste it here..

Regards

Surendra

[vishalpatil86]

ap03#show lwapp client rcb

AdminState                  :  ADMIN_ENABLED
SwVer                       :  3.0.51.0
NumFilledSlots              :  0
Name                        :  GUEST_9TH_03
Location                    :  default location
MwarName                    :
MwarMacAddr                 :  ffff.ffff.2fbf
MwarHwVer                   :  0.0.0.0
ApMode                      :  Local
OperationState              :  DISCOVERY