ā06-25-2018 04:36 AM - edited ā07-05-2021 08:47 AM
Hello
I am Tadele
I need help soon possible, i am now try to configure the WLC 2504 so in my management plan IP address didn't work so i want to try to reset but its not work the default address its not communicate with my laptop where as the console cable didn't get so please try to me help soon.
ā06-25-2018 04:50 AM
Hi Tadele
To factory reset a WLC 2504 you restart the WLC and connect a console cable. When you are prompted with the login you can enter "recover-config". The WLC will then reboot and remove all config.
Regards,
Jonas
ā06-25-2018 05:28 AM
ā06-25-2018 06:15 AM
No problem,
I dont quite grasp what you wrote but console access is a must to reset the WLC.
Regards,
Jonas
ā06-25-2018 06:35 AM - edited ā06-25-2018 06:37 AM
Hi Jonas
I have done initial configuration with GUI.
But after initial configuration i cant access it with GUI via its management IP. I can't even access it though the console. The console CLI displays black screen. After troubleshooting for a some time, i reset it manually. However i can't access it even after resetting.
FYI WLC 2504 has resetting button (hole).
ā06-25-2018 06:47 AM
ā06-25-2018 06:56 AM
ā06-25-2018 07:29 AM
Hi,
Ok, verify that you have set up the serial interface on your PC.
Easiest would be if you have a switch you can test the console on so you know that the console works on your PC.
If that works and you still don't get anything on the console during boot I would open a TAC case sense it sound like you may need to do a RMA.
regards,
Jonas
ā06-25-2018 07:44 AM
ā06-25-2018 05:29 AM
ā04-29-2024 06:09 PM
Whether the license certificate will be lost after AC reset buttonļ¼My certificate may be a permanent certificate, I do not have a certificate backupć
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide