Hello ,
I want to bring up the secondary of the controller on a 1Gig connection to a C3560CX switch for our guest network :
(Cisco Controller) >FP0.
Port SFP Vendor Transceiver Type OUI PartNumber Rev SerialNumber DateCode Auth
1 CISCO-AVAGO (0x40)10G BASE-LR SFBR-7600SDZ-CS3 1.4 AGD1750V0FB 131214 ok
2 CISCO-FINISAR (0x01)1000BaseSX FTLF8519P2BCL-CS 0000 FNS11010JVL 070104 ok
FP0.
(Cisco Controller) >
on the switch
t configuration : 186 bytes
!
interface GigabitEthernet0/16
switchport
switchport mode trunk
GuestWiFiSw#sh int statusGi0/16 notconnect 1 auto auto 1000BaseSX SFP
sho inv
NAME: "GigabitEthernet0/16", DESCR: "1000BaseSX SFP"
PID: , VID: , SN: FNS142105RS
according to Cisco it should take regular 1G SFPs not just SFP+
“ Small Form-Factor Pluggable (SFP) options (only Cisco SFPs supported), including S-Class Optics”
Changed SPFs, ports on the switch , cables , I even tried the fiber to copper SFP , but nothing is coming up. rebooted controller as per CSCu bug
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuq45137/?referring_site=bugquickviewredir
the port is enabled in the config on the controller. Any ideas?
we're running 8.2
Thanks in advance
