prefer band for specific client

[jiripijacek]

hi, my wifi client prefer 5ghz band, but its not good in our building, i want to switch him to 2.4Ghz, is there some solution in WLC? I mean all time prefer 2,4Ghz for specified MAC address of client. I dont want change SSID, thank you.

[balaji.bandi]

Instead of changing from WLC, why not change from client end try only 2.4 only wifi interface config ?

[jiripijacek]

client doesnt support change/prefer band

[balaji.bandi]

that is the best we suggest, most of recent adapter that option.

if not you need to disable from WLC side, this effects all the users who connected ? if that works then go ahead the route.

[Kasun Bandara · Accepted solution]

client device is the place where band selection is happening. you can disable/enable band in WLC globally. WLC cannot configure for specific MAC address for band selection

[jiripijacek]

thanks to mikrotik. easy solution via Acces List/Connect list per interface