cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1077
Views
0
Helpful
4
Replies

Problem- SSID is ON and OFF in Cisco 892W-AGN

aakashojha
Level 1
Level 1

Hi team,

I have a strange error in Cisco CISCO892W-AGN-E-K9 that i bought for our clients a month back.

- the router doesn't display the SSID for a longer period. Its like on and off of the SSID, showing sometimes and sometimes blank for the same device (Laptop/ Mobile/ or other Wireless Devices) within the range.

The router is in my office, but sometimes my laptop is connected, and sometimes it does not connect, and it is same with my other friends laptop.

Is it a problem with the device, configuration or the IOS issues?

Please help.

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame

Connect to the built-in WAP and post the output to the following commands:

1.  sh version;

2.  dir; and

3.  sh log

#show version

Cisco IOS Software, C890 Software (C890-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2012 by Cisco Systems, Inc.

Compiled Wed 21-Mar-12 01:40 by prod_rel_team

ROM: System Bootstrap, Version 12.4(22r)YB3, RELEASE SOFTWARE (fc1)

show log

Syslog logging: enabled (0 messages dropped, 2 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

No Inactive Message Discriminator.

     Console logging: level debugging, 45 messages logged, xml disabled,

                     filtering disabled

    Monitor logging: level debugging, 0 messages logged, xml disabled,

                     filtering disabled

    Buffer logging:  level debugging, 45 messages logged, xml disabled,

                    filtering disabled

    Exception Logging: size (4096 bytes)

    Count and timestamp logging messages: disabled

    Persistent logging: disabled

No active filter modules.

    Trap logging: level informational, 48 message lines logged

        Logging Source-Interface:       VRF Name:

Configurations--

config below-

dot11 syslog

!

dot11 ssid NWEDC

   authentication open

   authentication key-management wpa version 2

   guest-mode

   wpa-psk ascii 7 1102161612020003162F2A

!

!

!

username nwedc privilege 15 secret 5 $1$.SrJ$u3EVvjrMbli/I6UODVJoW.

!

!

bridge irb

!

!

interface Dot11Radio0

no ip address

no ip route-cache

!

encryption mode ciphers tkip

!

ssid NWEDC

!

antenna gain 0

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface Dot11Radio1

no ip address

no ip route-cache

shutdown

antenna gain 0

no dfs band block

channel dfs

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

!

interface GigabitEthernet0

description the embedded AP GigabitEthernet 0 is an internal interface connecting AP with the host router

no ip address

no ip route-cache

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

!

interface BVI1

ip address 192.168.1.10 255.255.255.0

no ip route-cache

!

!

interface wlan-ap0

description Service module interface to manage the embedded AP

ip unnumbered Vlan1

arp timeout 0


Ummmmm ...

Sorry, I think I wasn't being clear.  Can you post the following output from the WAP?

1.  sh version;

2.  dir; and

3.  sh log

Oops i was out for a while, sh version , dir and shlog listed-

#show log
Syslog logging: enabled (0 messages dropped, 2 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.



No Inactive Message Discriminator.


    Console logging: level debugging, 43 messages logged, xml disabled,
                     filtering disabled
    Monitor logging: level debugging, 0 messages logged, xml disabled,
                     filtering disabled
    Buffer logging:  level debugging, 43 messages logged, xml disabled,
                    filtering disabled
    Exception Logging: size (4096 bytes)
    Count and timestamp logging messages: disabled
    Persistent logging: disabled

No active filter modules.

    Trap logging: level informational, 46 message lines logged
        Logging Source-Interface:       VRF Name:

#show version
Cisco IOS Software, C890 Software (C890-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Wed 21-Mar-12 01:40 by prod_rel_team

ROM: System Bootstrap, Version 12.4(22r)YB3, RELEASE SOFTWARE (fc1)

IID uptime is 1 hour, 51 minutes
System returned to ROM by power-on
System restarted at 05:19:16 UTC Fri Jan 11 2013
System image file is "flash:c890-universalk9-mz.151-4.M4.bin"
Last reload type: Normal Reload


This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

Cisco 892 (MPC8300) processor (revision 1.0) with 498688K/25600K bytes of memory.
Processor board ID FGL1636279A

9 FastEthernet interfaces
2 Gigabit Ethernet interfaces
1 ISDN Basic Rate interface
1 terminal line
1 Virtual Private Network (VPN) Module
1 cisco Embedded AP (s)
256K bytes of non-volatile configuration memory.
250880K bytes of ATA CompactFlash (Read/Write)


License Info:

License UDI:

-------------------------------------------------
Device#   PID                   SN
-------------------------------------------------
*0        CISCO892W-AGN-E-K9    FGL1636279A



License Information for 'c890'
    License Level: advipservices   Type: Permanent
    Next reboot license Level: advipservices


Configuration register is 0x2102

#dir
Directory of flash:/

    1  -rw-    40863252   Mar 1 1984 00:01:00 +00:00  c890-universalk9-mz.151-4.M4.bin
    2  -rw-        3700   Sep 8 2012 23:00:32 +00:00  cpconfig-89xW.cfg
    3  -rw-     3000320   Sep 8 2012 23:00:46 +00:00  cpexpress.tar
    4  -rw-        1038   Sep 8 2012 23:00:52 +00:00  home.shtml
    5  -rw-      122880   Sep 8 2012 23:00:58 +00:00  home.tar
    6  -rw-     1697952   Sep 8 2012 23:01:44 +00:00  securedesktop-ios-3.1.1.45-k9.pkg
    7  -rw-      415956   Sep 8 2012 23:01:50 +00:00  sslclient-win-1.1.4.176.pkg

256610304 bytes total (210493440 bytes free)
Review Cisco Networking for a $25 gift card