06-08-2015 10:41 AM - edited 07-05-2021 03:21 AM
Hello i am from Venezuela
I have AIR-CAP1702I-A-K9, but i cant access it through console,ssh, telnet, i know that there are two firmware:
1) Autonamos
2) Lightweight
I bealive that my AP 1700 comes with Lightweigth, but a i dont have any controller, so i want access to the AP and become it to autonumus, so my questions are:
1) The AP 1700I work stand alone
2) How can i access it without cisco controller?
best regars
06-08-2015 01:38 PM
https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa
06-10-2015 03:29 AM
https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points
https://supportforums.cisco.com/document/71501/installing-autonomous-ios-aios-lightweight-ap-cli
06-10-2015 04:00 AM
1) The AP 1700I work stand alone?
The 1700 series access point is available in both controller-based (Unified) and standalone (Autonomous) configurations, and supports:
2) How can i access it without cisco controller?
You need to have an account on Cisco.com to access Cisco Tech Zone. If you do not have an account, you can create one by clicking Register Now on the Log In page.
06-12-2015 10:05 PM
Hold on, hold on ... This is a 1700 right?
Console into the AP (username/password: "cisco") and in enable mode, enter this command: config capwap ap autonomous
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide