01-24-2013 11:48 PM - edited 07-03-2021 11:25 PM
Hello,
I'm currently investigating on Aironet 2600 accesspoints.
There are two model numbers, CAP2600 for controller based and SAP2600 for standalone/autonomous.
My question now is, when I purchase a SAP2600 (=autonomous model), can I later convert it to run on a WLC and also back again to autonomous when needed?
Thanks in advance,
kind regards
Solved! Go to Solution.
01-25-2013 05:35 AM
Here are the instructions if you do need to convert. This is Leo's favorite link:
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
01-25-2013 12:45 AM
Yes you can. Look up the procedures but they're simple enough, the only thing I'd make sure is that you can access the APs physically especially for the lightweight to autonomous move.
Thanks
Chris
01-25-2013 05:35 AM
Here are the instructions if you do need to convert. This is Leo's favorite link:
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
01-25-2013 05:39 AM
Ok thanks, so the procedures are the same as with the older models. I just wasn't sure about that.
01-25-2013 06:22 AM
Yes it is
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
01-25-2013 06:23 AM
Here is a video also:)
https://supportforums.cisco.com/videos/2089
Thanks,
Scott
Help out other by using the rating system and marking answered questions as "Answered"
01-25-2013 03:57 PM
Here are the instructions if you do need to convert. This is Leo's favorite link:
LOL
01-25-2013 04:26 PM
+5 Leo for your link I borrowed:) haha
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide