Router and L2 Switch

[riyazpatel424]

Dear Sir/Madam,

           Is it possible to know bandwidth utilization in network using command in L2 switch and Router ???

[Deepak Kumar]

Hi,

There is no such direct command for the same but you can check 

"

router#show interface gig 1/0/1 <Interface ID>

   Five minute input rate 0 bits/sec, 0 packets/sec
Five minute output rate 2000 bits/sec, 4 packets/sec

Here, It will show input and output rate. This command will work on both router and switch (Cat).

Regards,

Deepak Kumar

[riyazpatel424]

Thank you Deepak Sir,

               Sir is there any command for check network traffic between source IP to destination IP in router??

[Deepak Kumar]

Hi,

There are few commands for the same but what is your purpose? This is main thing:

1. Show IP Socket

2. Show tcp sessions

3. show ip accounting <If it is enabled>

4. show ip nat translations

Regards,

Deepak kUmar

[Deepak Kumar]

Hi,

There are few commands for the same but what is your purpose? This is main thing:

1. Show IP Socket

2. Show tcp sessions

3. show ip accounting <If it is enabled>
4. show ip nat translations

Regards,

Deepak kUmar

[riyazpatel424]

Sir, My purpose is check bandwidth utilisation with port details, source and destination information in router.

[Deepak Kumar]

Hi,

I think a command "show ip nat translations" is best solution for you.

Regards,

Deepak Kumar

[riyazpatel424]

Thank you Sir..