09-24-2018 02:40 AM - edited 07-05-2021 09:13 AM
Dear Sir/Madam,
Is it possible to know bandwidth utilization in network using command in L2 switch and Router ???
09-24-2018 03:09 AM
Hi,
There is no such direct command for the same but you can check
"
router#show interface gig 1/0/1 <Interface ID>
Five minute input rate 0 bits/sec, 0 packets/sec
Five minute output rate 2000 bits/sec, 4 packets/sec
Here, It will show input and output rate. This command will work on both router and switch (Cat).
Regards,
Deepak Kumar
09-24-2018 03:13 AM
Thank you Deepak Sir,
Sir is there any command for check network traffic between source IP to destination IP in router??
09-24-2018 03:21 AM
Hi,
There are few commands for the same but what is your purpose? This is main thing:
1. Show IP Socket
2. Show tcp sessions
3. show ip accounting <If it is enabled>
4. show ip nat translations
Regards,
Deepak kUmar
09-24-2018 03:21 AM
Hi,
There are few commands for the same but what is your purpose? This is main thing:
1. Show IP Socket
2. Show tcp sessions
3. show ip accounting <If it is enabled>
4. show ip nat translations
Regards,
Deepak kUmar
09-24-2018 04:07 AM
Sir, My purpose is check bandwidth utilisation with port details, source and destination information in router.
09-24-2018 04:12 AM
Hi,
I think a command "show ip nat translations" is best solution for you.
Regards,
Deepak Kumar
09-26-2018 08:57 PM
Thank you Sir..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide