Can anyone assist. im setting up a aironet 2802-E ap as a standalone unit i.e its not going to join WLC. im new to the wireless environment but have done much research, in order for me to use this ap as a standalone unit, i need to convert to mobility express but im stuck here. Conversion to mobility express was a success, but still can't configure the ap. This ap is not going to join any WLC, it needs to be set up as autonomous mode but currently there's no image. Can anyone assist? is there an image i could use to use this ap as a stand alone unit?
To verify if the AP conversion to Mobility Express was successful then on the Console access you will see the Controller prompt. And also you can verify the "show version" output to confirm on the ME conversation as below:
AP Image type : MOBILITY EXPRESS IMAGE
AP Configuration : NOT MOBILITY EXPRESS CAPABLE
After the ME conversion, the AP will operate as Controller as well as the Master AP. However, the WLC mgmt and the AP will use 2 different IP addresses. On the Console access, use the command "apciscoshell" to login to the AP and check the details.
Listen: https://smarturl.it/CCRS8E33 Follow us: https://twitter.com/ciscochampion The goal for stadium and large venue Wi-Fi is to deliver an exceptional, fast, and reliable wireless experiences to tens of thousands of fan...
We are pleased to announce the immediate availability of the IOS-XE release 17.6.1 for the Catalyst Wireless Controllers. The new code is now posted on the CCO and can be found at this link:
This version now introduces experimental new feature, "Upgrade Advisor, targeted to one of common case generators: what are the supported versions and how to upgrade my current controllers and APs
It supports both AireOS and IOS-XE, covering since ...
Thank you for the overwhelming response to the First and Second EFT refresh of 8.10MR6!
We are excited to announce the third refresh of 8.10 MR6 EFT Program for PRODUCTION deployments.
While the CCO release of 8.10MR6 is just a few we...
Greetings!Thank you for the overwhelming response and feedback for the first 17.3.4 EFT/Beta release.
Now we are excited to announce the second refresh of 17.3.4 EFT/Beta Program for PRODUCTION deployments.
This release is the s...