SFP port configuration on switch

[petercinvest]

I have two SFP port on my layer 2 switch and I want to connect to my WLC 5508. is there any specific setting required compared to normal gigabit interface port?

so I just simply setup trunk in the SFP port, is it enough? thanks

[Scott Fella]

That is really the basic way to do it.  Take a look at some guides for reference.

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-vlan/68100-wlan-controllers-vlans.html#configs

-Scott

*** Please rate helpful posts ***

[petercinvest]

The link is quite ok, but my question is whether any specific configuration required in SFP port compared with normal trunk port?

also any command to list the SFP port  and POE port in my layer 3 switch.

if my switch don't have SFP port, can I connect SFP port from WLC and non-SFP port in my core switch? thanks

[Scott Fella]

No special configuration because it comes up as a normal port.  The WLC can connect to any port as long as it's a gigabit port.  Commands for your switch you will have to look at your switch configuration guide. 

-Scott 

*** Please rate helpful posts ***

[petercinvest]

I use service port to connect to WLC, how do I export WLC configuarion file to my laptop instead of tftp? 

[Scott Fella]

All the info can be found in the configuration guide

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70mfw.html#pgfId-1063850

-Scott 

*** Please rate helpful posts ***

[mohanak]

Refer link : http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-2/configuration/guide/cg/cg_ports_interfaces.pdf

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-0/configuration/guide/c70/c70mint.html