SNMP operation to Device failed: Attempt to set conflicting attribute value

[justinwray]

after upgrading the firmware on the wireless lan controller 5.2.178.0 on my cisco 4402 wlc's and rebooted the devices, I am getting matches on the audit status between whats on the contoller and the wcs software. so i am trying to apply whats in the wcs templates created for the controller and i am getting this error.

SNMP operation to Device failed:                                  Attempt to set conflicting attribute value

I am thinking that i need to rebooted the wlc's again because from the error it sounds like the values that i am trying to write to the controllers are already present

anyone ever seen this error?

thanks.

[Kayle Miller]

Justin,

   If the controllers are workign properly and everything seems good, then the first thing I would do is update the WCS configuration from the controllers doing then do an audit compare again..  I have also seen this issue is you have alot of AP groups or H-reap groups.

Hope this helps.