06-13-2011 07:26 AM - edited 07-03-2021 08:18 PM
I would like to know if the 1040 AP have support to Band Select on controller-based mode, below there are two documents saying different things, Can anyone clarify this?
AP At-a-glance - Says that bandselect is supported on 1040 for controller-based:
http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps10981/at_a_glance_c45-636090.pdf
The configuration guide 7.0.166 says that Band selection can be used only with Cisco Aironet 1140 and 1250, 1260, and 3500 Series access points:
http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70ccfg.html#wp1934253
Solved! Go to Solution.
06-13-2011 09:09 AM
Hi,
Band select is supported on 1040.. we have the internal discussion going on, which means Cisco confidential.. Please contact your Accounts team to get more details!!
Lemme know if this answered ur question and please dont forget to rate the usefull posts!!
Regards
Surendra
06-13-2011 09:09 AM
Hi,
Band select is supported on 1040.. we have the internal discussion going on, which means Cisco confidential.. Please contact your Accounts team to get more details!!
Lemme know if this answered ur question and please dont forget to rate the usefull posts!!
Regards
Surendra
01-29-2012 10:00 AM
Hi Surendra,
Any update on this? Is band select now supported on the 1040 series AP?
Regards,
Eoin.
01-29-2012 01:07 PM
Band Select is enabled on the 1040. Someone just forgot to update the documentation.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide