Transmit power control settings in 9800 controller

[Linkwave]

Hello,

I hope someone can help me figure out how to set up manually specific Tx power levels, channels and channel width in the 9800 series controller for each AP or groups of APs. 

Thank you in advance.

[tobies]

Okay, @skronawithleitner just gave me this solution:

Do NOT enter config-mode, but stay in exec. There you have the ability so set channel, tx-power and antenna-gain via CLI:

ap name APNAME dot11 5ghz slot 1 txpower 2

[denmendoza]

wow, tried just now, and it worked (not entering config-mode)... 

[tyoung008]

Thank you @tobies !

I ran into a customer that had manual power and channel set for 200+ APs.  The CLI commands also have an auto option to revert back to DCA and DTPC.

ap name APNAME dot11 24ghz slot 0 txpower auto
ap name APNAME dot11 24ghz slot 0 channel auto

That makes reverting back to dynamic much easier!

Tom