Hello all, I need some advise.I am trying to set up a Guest WLAN on Mobility Express with the ability to authorize guests through a ISE Guest Portal(Sponsored or any other kind).I have ME 8.5.151 and i purposely upgrade it to 8.10.130.But in this ve...
I would like to bring to your attention an observation regarding the link speeds of different access point models connected to our Cisco C9300 PoE+ switch. We currently have three types of APs in operation: C9200 AP – Showing 2500 Mbps on WLC C2800...
Is the column of wireless client monitor below can be customized? I need to showing the client devices name where now i only can see the name if we click on each client. Tyr to exporting the data but the device name is not showing.
I have wrong assigment license for my AP, previously i assign DNA Advantages in the controller and i change to DNA Essential because this is license was purchased. When the AP using DNA Advantages then in the smart account i have insufficient license...
Why ap is blinking red/green 9120ax
HiWe are using a CW9166 Access Point managed by a C9800-CL Wireless LAN Controller (vWLC) running image C9800-CL-universalk9.17.15.*Through the vWLC GUI, underConfiguration > Radio Configuration > High Throughput,we reduced the number of spatial stre...
Hi I have an ap 9130 I want to run an wlc in EWC mode. I followed this guide However when I cmd ap-type ewc-ap tftp://192.168.0.82/ap1g6a tftp://192.168.0.82/C9800-AP-iosxe-wlc.bin Image upgrade not needed, changing AP Type to EWC-APa show version AP...
Hello, I try create SSID with Web auth for my guest. When i select 'none' in Layer2 security and tick Web Policy in Layer3 why the SSID is not showing? If i untick the Web Policy in Layer3 then the SSID is showing with open authentication.
In wireless environment should we enable the 'Band Select' or not? Based on this document enabling the Band Select will make 5Ghz will more attractive so the client will try to join to the 5Ghz first. https://www.cisco.com/c/en/us/td/docs/wireless/co...
Good day. Tell me why the radius server test command is not accepted? It says: Invalid input detected at.
Hi team, We are using the C9105AXI-S AP with the EWC image installed, operating in standalone mode. This is a new AP, but when connected to our current network, it occasionally gets disconnected, and the LED indicator flashes alternately green and re...
Hi all,As the title suggests - would we need to reboot a WLC or its AP's if we change the highlighted field? I've read the associated configuration guide and there's no mention of a reboot but wanted to ask those in the field.
I'm currently running an AIR-CT5520 with RTU licenses and planning to migrate to a CW9800M controller. Since the 9800 uses Smart Licensing, how can I migrate or convert my existing RTU licenses for use on the new platform? Any official migration proc...
I have a 9800CL qcow image running in Linux KVM. I have 3 ports from the NIC assigned to the 9800CL by direct attachment. They show up fine as gig interfaces. I can configure them as no switchport and communicate across the network. However, when I s...
Would anyone please help confirm the most suitable software version for the Catalyst CW9800M WLC that supports the following AP models?current 5520 WLC version (8.10.196.0)Cisco Catalyst 9120AXI-KCisco Catalyst 9105AXW-KAIR-AP1832I-Z-K9AIR-AP2802I-Z-...
