I have a point to multi point bridge currently being serviced by 1400 series bridges. I need to replace them and I am planning on using the 1562 series AP. The distance between the main building and the remoted buildings is 1700 feet. I measure the signal from the 1400 and it is in the mid -60s. I tested a 1562D and the signal was -75 to -80. I tried a 1562E with an AIR-ANT5114 and I get -72 to -80. Will this be good enough and provide sufficient throughput? It seems to be a weaker signal than I would like. Is there a better AP and antenna combination? The remote buildings are 3 of them and the APs for them would be about 150 feet apart.
I set up the 1562s with Mobility Express and set the power level to 1 and the antenna gain to 28. It was mounted to a 25 foot pole. It was clear line of sight. And we went to the other end and measured the signal strength with a Fluke meter. It seemed odd to me too. I expected better results. Have others used this or a similar configuration at the 1500 to 2000 foot distance and gotten good results?
I have done my share of mesh deployments and that isn’t right. Maybe you are comparing 2.4ghz backhaul vs 5ghz, but with that overall TX, it should be better.
That is why I was surprised myself. Yes that is on the 5Ghz. When I tested the same distance using the 1562D we got around the mid -50s for the 2.4Ghz and around -80 for the 5Ghz. It seems odd to me. I can test again to verify. If these are to be dedicated to be only used as bridges, can I use the 2.4Ghz instead of 5Ghz for the bridge?
Have you used these devices for bridges at that kind of distance, approximately 1700 feet? I used to do many bridges with the 1400's and never had an issue. It is my first time utilizing the 1562s and want to make sure I will get decent throughput. Or is there something else you would recommend?
Learn, share, save
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
