01-05-2011 11:08 AM - edited 07-03-2021 07:37 PM
Is there a way to set the WCS to automatically to do a port scan when a new Rogue AP is found?
Solved! Go to Solution.
01-06-2011 07:07 AM
01-05-2011 09:39 PM
If you have WCS configured with the switches SNMP info, you can have WCS track down exactly what port the rogue AP (and Client) are on. Is this wat you are looking for??
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpful
01-06-2011 07:00 AM
No. I know how to do it manually. I would like to know if there is a way to have WCS automatically do a port trace as soon as it sees a new Rogue AP.
01-06-2011 07:07 AM
Currently the only way to initiate the switchport
trace is manually.
01-06-2011 07:12 AM
ha ha you were quick was about to reply the same!! Anyways thanku..
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide