Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I need to do a site survey using my wireless "N" AP.  The AP is a Cisco 1252G.Is there any way I can make the AP broadcast an ssid without plugging it into the network and having it join the wireless controller?I will mount the AP in a hallway were t...

polleyjb01 by Level 2
  • 1634 Views
  • 10 replies
  • 0 Helpful votes

I have my WLC2106 on a network with no VLANs and no 802.1q.  I have a DHCP server already on the LAN.However, it seems like I still need to configure the WLC to proxy the DHCP requests from the wireless clients.  Is there any way for me to run the WL...

lgmarkis by Community Member
  • 1482 Views
  • 3 replies
  • 0 Helpful votes

We have an instance where changes were (supposedly) made to one of the IP addresses on a WLC, but the next morning, the old IP address was there. Does the WCS automatically load a config if it sees a difference to what it believes should be loaded? (...

swakelen by Level 2
  • 602 Views
  • 1 replies
  • 0 Helpful votes

I have a local mode 1242 LWAP that gets dragged around from city to city as a mobile WLAN-in-a-Can.  So far it phones home and re-joins it's WiSM properly.  In actual use no more than six laptops can connect and that's the problem.I set the globally ...

hi! In an autonomous APs setup environment with the dhcp configured in 2 of the APs (within the same network segment), when the user move from one APs to another APs, will it caused 2 dhcp address leases in both of the dhcp svrs and caused conflict?T...

dkblee by Level 7
  • 1065 Views
  • 5 replies
  • 0 Helpful votes

Trying to setup wireless on 1801w ISR.  Wired access to Internet and LAN works fine (Vlan1); however, wireless (Vlan2) does not. Trying to setup wireless "guest" access with Internet access only (no access to LAN).Wireless will not come up.  Dot11Rad...

Gday Everyone,I have been getting this error recently. Any suggestions out there%USMDB-3-MSGTAG030: usmdb_apf.c:262 For information regarding Emergency image Version,Please refer Controller documents. I got WLC4402, software ver 6.0.188

Gday Everyone,Been working on wireless maps for wcs. While creating the maps, do the internal structure (rooms, bathrooms etc ) have to be exactly scaled? Will just a layout of the rooms work? Anyone who has done the maps, how have you been doing it?...

Is it possible to have one broadcasting SSID but clients seperated by, lets say say 7 different vlans in the WLC?  For example- each floor would be seperated by its own vlan and dchp pool, but they all connect to one SSID in the controller.  From wha...

decrypted08 by Community Member
  • 8760 Views
  • 5 replies
  • 0 Helpful votes

we are using the Cisco Spectrum Expert software and hardware to deploy a wireless solution.  we are doing surveys all over the US and I would like be able to create a good quality report for each site.  Is there a utility or program that the informat...

thomas.moore by Community Member
  • 1174 Views
  • 2 replies
  • 0 Helpful votes

hi! can i connect a 1242 cisco ap (autonomous setup) into a non cisco switch (eg. linksys or dlink) and configured it as a guest vlan but user will need to key in password and username to login?

dkblee by Level 7
  • 976 Views
  • 3 replies
  • 0 Helpful votes

hello I do not have a problem with the wireless module Hertzian music streamen always succeed the module reboot know there a sometimes someone solution??

pcfreak49 by Level 7
  • 1345 Views
  • 10 replies
  • 0 Helpful votes

I am connecting an old aironet 340 to a new Aironet 1300. I can get the association working and aironets talking. The problem is the 340 will not forward on any TCIP data. The association is connected and you can ping from the 1300 to the 340 and bac...

jamesh1973 by Community Member
  • 2235 Views
  • 7 replies
  • 0 Helpful votes

We have a WLC 2100 series controller running on our LAN, its started having alot of problems and needs rebooting every 30 mins before anyone can connect.We've just noticed the software its running is - 4.0.217.0, to upgrade we need to incrementaly go...

andy_4578 by Level 5
  • 4383 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card