05-24-2023 09:57 PM
Hi All ,
I test AP9136 with WLC 9800-40 but I found the 5Ghz Slot 2 Admin Disable and 6Ghz Radio Operation Status down .
For Policy Tag / Site Tag / RF Tag , I already configure not use default configuration .
Please advise me .
Solved! Go to Solution.
05-25-2023 11:23 PM
Upgrade to 17.9.3.
If the 6E is still not enabled, talk to the Cisco AM/SE/Wireless PSS. Different countries have different firmware version required to operate 6E.
For instance, we were told that Australia requires IOS-XE version 17.12.x.
05-24-2023 10:32 PM
- Reboot the AP , just after boot connect to it and issue the command show logging ; check for additional info's,
M.
05-25-2023 12:22 AM
@marce1000
Can you help me for the focus the log of AP9136? Thank you.
05-25-2023 12:29 AM
What is the firmware of the controller?
What is the Regulatory Domain of the AP?
05-25-2023 04:41 AM
@Leo Laohoo
What is the firmware of the controller?
- C9800 running versuon 17.9.2
What is the Regulatory Domain of the AP?
- ROW with country Thailand (TH)
05-25-2023 04:55 AM
>..- ROW with country Thailand (TH)
I don't know if this is related but if the particular regulatory domain does not support 6E the radio could remain disabled , according to https://www.wi-fi.org/countries-enabling-wi-fi-in-6-ghz-wi-fi-6e , Thailand is considering...
M.
05-25-2023 05:38 AM
In Thailand I see information we can use radio 5.925-6.425 Ghz first . The regulatory domain of AP make Operation status down?
05-25-2023 09:26 AM
- Check the full AP model on the packing box (or on the AP) ; you may need extra configuring steps on the controller as in :
https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/217734-connect-and-join-a-row-domain-access-po.html
M.
05-25-2023 08:40 PM
@marce1000
AP Model is C9136I-ROW . I try to change the country code that allow radio 6Ghz in other country. It's working fine but after I use my country code still not working I think might be IOS-XE or not ?
Reference in attached
05-25-2023 11:23 PM
Upgrade to 17.9.3.
If the 6E is still not enabled, talk to the Cisco AM/SE/Wireless PSS. Different countries have different firmware version required to operate 6E.
For instance, we were told that Australia requires IOS-XE version 17.12.x.
05-26-2023 01:56 AM
@Leo Laohoo
I already contact Local Cisco SE . I think may be waiting new IOS-XE for support my county .