Windows 10 EAP-TEAP Chaining with ISE on Wireless

[Puru]

Hi,

We are currently using EAP-FAST (Cisco AnyConnect) for wireless Authentication (User and Machine).

Our new setup as follows.

• Cisco ISE 3.1 Patch 3
• Windows 10 Version 20H2

As per the configuration guide from cisco given below, they talk about using TEAP on Wired network.

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/216510-eap-chaining-with-teap.html

https://www.ise-support.com/2020/05/29/using-teap-for-eap-chaining/

Question: Does EAP-TEAP can be enabled on wireless network?

If yes, looking for some guidance on how to do the same.

Regards,

Puru

[Haydn Andrews · Accepted solution]

The cisco guide you showed actually has the example of TEAP for wireless in the ISE policy.

Take a look at this article
https://community.cisco.com/t5/security-knowledge-base/teap-for-windows-10-using-group-policy-and-ise-teap/ta-p/4134289 

Video down the bottom shows it from Windows side

[Puru]

Hi Haydn Andrews,

Thank you so much for the details. This helped and worked for me. I was able to test EAP-TEAP on Wireless.

Regards,

Puru

Thank you