06-24-2009 08:33 AM - edited 07-03-2021 05:45 PM
Hello! I have a wireless controller 4404, running 4.2.176.0 code. I have LAG enabled but currently have only 2 ports used, I am planning on connnecting the other two ports soon. Will this cause an outage? I am thinking no, but I want to see if anyone has ever done this and what the outcome was. Thank you.
06-24-2009 04:25 PM
Are you plugging the last 2 uplinks to the same switch?
Just make sure that STP is DISABLED and it should be fine.
06-25-2009 07:54 AM
Yes I am plugging the last two uplinks to the same switch, but on a different module. When you say make sure that STP is disabled, what are you referring to? Spanning-tree portfast?
06-25-2009 03:41 PM
Yes. Just make sure STP Portfast is disabled.
06-26-2009 04:40 AM
Also make sure you create an ap-manager interface for every active port on the controller.
06-27-2009 11:39 AM
LAG is enabled so there will only be one AP Manager interface. No requirement/ability to create additional interfaces.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide