01-31-2022 07:43 AM
Hi,
I have 2 SSIDs and have been asked to limit the bandwidth of Guest ssid.
I check both SSIDs and both have QoS as shown below. Please see File 1.
MY first question is which one of the QoS is it using right now as I think that is is not using any specific. (Platinium,Gold , Silver or Bronze)
I have been asked to limit the bandwith for Guest to 100M and give the other SSID the maximum bandwidth.
Can anyone help me to implement this please.
Thanks
Tazio
01-31-2022 07:50 AM
I would suggest you take a look at a few guides on WLC bandwidth limits. Here is one that shows you have to implement bandwidth, but there are a lot more out there for reference.
Wireless Bi-Directional Rate Limiting Deployment Guide - Cisco
02-01-2022 05:16 AM
Hi,
Thanks a lot , i am going through the document.
Tazio
01-31-2022 07:54 AM
Here is an other good blog post about rate limit
https://mrncciew.com/2013/05/01/per-user-rate-limit-in-wlan/
CJ
01-31-2022 02:15 PM
@Tazio4436 wrote:
I have been asked to limit the bandwith for Guest to 100M and give the other SSID the maximum bandwidth.
Is this a 2504?
QoS Bandwidth Contracts are only supported on 5508/WiSM2, 5520/8540/3504. 2504 does not support this feature.
02-01-2022 05:17 AM
Hi,
Yes it is a 2504.
Does this means i cannot control bandwidth on 2504 or there are other ways?
Thanks
Tazio
02-01-2022 01:57 PM
What about enforcing the limits on the upstream device/firewall?
And it is too long ago to really remember, but I think I had it running on the 2504 that I used one Interface for guest with 100 MBit Port-speed and the other interface with Gigabit because in that network there was no device that could do bandwidth-limits.
Won't win any design awards, but if I remember right, it worked as expected.
02-01-2022 02:54 PM
Enable traffic-shaping policy in the core.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide