Wireless

Hi, I have an issue of AP restart with the reason not known. I have check the log from the switch and only link up and down happened at the time. Trying to find more information of the reason but didn't have much. Anyone ever found this? ------------...

Are Self Identifying Antennas supported on EWC on a 9120?Thanks.

Im trying to figure out if there is any difference in available channels on these two regulatory domains for a installation in China. There have already (some time back) been deployed C domain APs, but now we have got new H domain APs. Is there anyth...

Hello Cisco Team, Can anyone share Cisco Catalyst 9100 EWC access point configuration for Cisco ISE. We have a Cisco ISE in network. Cisco ISE need to authenticate network devices. Then only we can configure Wireless Network.   Please share configura...

Greetings, Kindly advise if Cisco Embedded Wireless controller support Active Directory integration via LDAP. Has anyone configured and tested this?

I am in the process of moving our 5520 WLC to a 9800-cl, and thus far everything works with exception of our CWA portal. We are running ISE 3.0 for our guest/byod portal, and everything continues to work from our 5520 wlc, but when I connect to our g...

Understanded

Hello,Anyone know why i can't access to the WLC if i access the WLC from VLAN which the VLAN listed in controller interface?On the pic we can see i have some VLAN and if i access from that VLAN , the WLC can't be accessed.

Hi All, Hope you are well. I've enabled RADIUS authentication using a Kerio NG511 in order to authenticate the users. I have an Cisco 9800 series and in between both of them, there is a Cisco 9200 Stack. I am attempting to set the user authentication...

Hey all-I have a WLC 5508 on my network.  Recently mobile phones can connect to the wireless network and obtain a valid IP address.  This IP is pingable from a workstation anywhere else on the network and we are able to ping internal interface of rou...

Hello,can we make wireless 5Ghz only operate on 802.11n/ac/ax only, mean disable 802.11a?

Hello,We have a SDA Fabric managed by our DNAC with our C9800 managing the underlay APs. The thing is we have configured different AP Zones to broadcast different set of SSIDs.Now we have the duty to deploy 800 APs, and we are looking for a way to in...

i am having issues joining new 1242LAP's to my controller.  i am receiving the follwing error on my controller:AAA Authentication Failure for UserName:5475d01144f0 User Type: WLAN USERusername is the MAC of my new 1242LAP.  older 1242LAP's have no is...