- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2012 06:35 AM - edited 07-03-2021 09:33 PM
I need to configure a 2504 wlc and two 1142 APs that I want to connect directly to the wlc. I've heard I can't use the PoE on port 3 and 4. If so, can I use power injectors instead?
I can't seem to get the APs to speak to the wlc. Using example below, how would I go about configuring this andwhen do i need to enable Dynamic AP Management? Appreciate all suggestions.
Example:
mgmt vlan 10
guest vlan 20
empolyee vlan 30
Wlan: Guest
Wlan: Employee
Solved! Go to Solution.
- Labels:
-
Wireless LAN Controller
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2012 06:46 AM
You can use the PoE ports but
Is not Cisco supported. The ap will have to obtain an ip address on the same vlan as the wlc management interface.
Thanks,
Scott Fella
Sent from my iPhone
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-10-2012 06:46 AM
You can use the PoE ports but
Is not Cisco supported. The ap will have to obtain an ip address on the same vlan as the wlc management interface.
Thanks,
Scott Fella
Sent from my iPhone
*** Please rate helpful posts ***
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2012 03:30 AM
Decided not to use the PoE port on the wlc, but used a regular PoE switch instead.
Thanks for you help!
Sent from Cisco Technical Support iPad App
