Wireless

Hello Support Team,I have a Windows 2008 R2 server, i want to configured NPS (Radius) Server on windows 2008 server for WLC client and AD users autentication.I am tried to configured but failed. AD users are not autenticated.have you any guide for wi...

On our public wi-fi network we have an acceptable use policy page that users must accept in order to access the internet.  However I would like to exclude a few devices from having to do this.  We have a couple of Kindle devices from a vendor that th...

Hello,            I have a cisco 857w ISR router. My wireless access point was working good until yesterday. Suddenly the wireless light is gone & there is no interface in the router named dot11. I could not even get into the interface configuration ...

Hello is there a way on a WLC5508 to push the same configuration on multiple APs in 1 shot?I need to change the High Availability settings on most of the APs (not all). And the only solution i find is to do 1 by 1... Tx for your answer .B.

Hi,My laptop running Spectrum Expert passed away and I can't find another laptop with a cardbus slot in my company. Does anyone knows of any USB or ExpressCard to Cardbus adapter out there? Been searching and I've found some CardBus to USB adaptors b...

Is it possible to see device information for equipmnet that is logged into the AP541N access point?  I was able to determine a specific IP address was eating a significant amount of bandwidth and was hoping to get the device information (name, type, ...

Hi,On autonomous AP's one can disable the bright status LED using the "led ....." command. But how can I disable the LED on a LAP-1131AG? The AP hangs in a bedroom so the light is quite annoying.Thanks!

I've been asked to generate some report data on a specific WLAN, a limited access WLAN that was added recently. We need to be able to report on "Average and Peak Number of clients (Total)" and "Total Bytes Transferred (all  APs)" on a per site basis....

My installation has 4 wired AP´s with 8dbi antennas. They are in a equidistante square position in a campus. Because I have only 3 non-overlaped channels, what is the best separation (in metres) between them?Actually they are 70m far away.Regards.

My question is, how i can limit the bandwidth for a all my client conect to the AP, i have a Aironet 1200 with the 12.2.15 code.Thanks in advance.

Can someone guide me to a website on BEst Practices for deplying Access Points?Thanks In Advance

For the past week, I've been looking to implement wireless technology at our educational site. We've conducted some tests with an AP1200 and we were satisfied with the performaces of 802.11a standards. Since one of our requirements is bandwith, we ar...

Hi,does Cisco make a 802.11g AP and if so what series is it?thanks,James

Hi all,We are using NCS 1.2 to monitor and manage our WLCs. We are also using  different Virtual Domains per region.On our network we are using Campus WLCs that anchor their traffic to Anchor WLCs behind a DMZ.When we add a Campus WLC  to NCS and try...