cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
686
Views
0
Helpful
5
Replies

WLC 5500

samt510
Level 1
Level 1

We have WLC 5500 and we need to create URL filter in ACL but We couldn't find URL ACLs  under access control list to do so. If you have a solution to help us please show me how?

5 Replies 5

balaji.bandi
Hall of Fame
Hall of Fame

what AirOS running on the WLC ? have you looked below URL :

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-4/b_URL_ACL_Enhanced_Deployment_Guide.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thank you for responding.

My WLC Model is 5508 and Software Version is 7.6.130.0

Rich R
VIP
VIP

5500 is not a WLC model - that could be a 5508 or 5520.  So what is the actual model of the WLC?
And as BB said - what version of AireOS software are you using on that WLC? (show sysinfo)
If you want to add URLs to an existing ACL (eg for pre-auth ACL) then use the little drop down arrow to the right of the ACL "Add-Remove URL" to edit the URL list.

Thank you for responding.

My WLC Model is 5508 and Software Version is 7.6.130.0.

I need to deny access to all website except for few.

Well as you can see from the documentation link BB provided URL filtering was only introduced in 8.4 code.

7.6 is very old - it went end of support and deferred 5 years ago!
https://www.cisco.com/c/en/us/products/collateral/wireless/8500-series-wireless-controllers/bulletin-c25-741067.html
The latest available release for 5508, which also supports URL ACLs, is 8.5.185.11 (link below).
You didn't mention what AP models you're using but you'll need to check the compatibility matrix (link below) to make sure your APs are supported in 8.5.

Review Cisco Networking for a $25 gift card