WLC- Client traffic details

[gija]

Hi all,

We are using 9800 series WLC and have 200 + Access points.

We need to know the total usage and applications used by each client. Is there any method to take this report over WLC?

[marce1000]

 - Not with a 'direct command(s)' as such , look into : https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-1/deployment-guide/c9800-avc-deployment-guide-rel-17-1.pdf

 M.

[jagan.chowdam]

If you have Cisco Prime Infrastructure, you can generate reports (Clients Performance/Application performance) and get details.

CJ

/*Please rate useful responses*/

[Haydn Andrews]

Prime or DNAC with AVC enabled on the WLC will give you the best data.

[Gaurav Kansal]

Hello

WLC 9800 can give only limited information like association history etc.or you can also use troubleshooting tab for more information.

Prime ,DNAC, syslog can give better information about client traffic usage

Good Luck

[gija]

Hi,

In DNAC, do we get the total data usage and uptime details (like, 1 GB usage in 45 mins) ?

[Scott Fella]

With any management tools, you get data collection at a specific time.  So most will provide a graph of amount of data and time.  To get application you need to have netflow configured and pushed to the tool.

From DNAc guide for application visibility.  
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/2-3-5/user_guide/b_cisco_dna_center_ug_2_3_5/b_cisco_dna_center_ug_2_3_5_chapter_01111.html

[Gaurav Kansal · Accepted solution]

Hello

Pls go through this link, this will tell you about report you can get from DNAC

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center-assurance/2-1-2/b_cisco_dna_assurance_2_1_2_ug/b_dnac_platform_ug_2_1_1_chapter_0110.html

Good Luck