Wireless

I have a secret problem with starting Cisco Access Point: CBW150AX-E-EU.When I connect it directly to the Cisco ASA 5506x, the AP does not want to connect at all. It means it doesn't get the address from DHCP. DHCP allocates a windows server. When I ...

Hello all,   I'm having an issue with clients connected on my Guest SSID configured with Web Authentication Splash Page. Basically by today (NO CHANGES NOR ACTIVITIES WERE DONE) all the clients which are trying to connect to this SSID cannot reach th...

Just opening this question to the group to get a feel from the community. I just started demoing a CW9162 and CW9166 and I noticed that many of my cheaper IoT devices are having a hard time either connecting to the correct AP or flat-out having bad p...

I am trying to upgrade my 2801i in mobility express from 8.5 to 8.10. Note:- My main wlc is already in 8.10, I need to upgrade another access point so that it can join main ME WLC.

Hi, Under Access Points ---->Radios, there are four items. The first one is 5GHz and second is 2.4GHz, third is 2.4GHz and fourth is 5GHz. Please see the below picture. This ap is 3702, I can see the ap at item 1 and 2, but i cannot see the ap at ite...

Hi all, First and foremost apologies if this doesn''t belong here. But I was wondering what the HA_EM-6-LOG: catchall XXXX messages are for on a 9800 WLC. I''ve been trying to get messages over to Graylog but it seems the current setup contains no me...

If I have a local site with LAN Network that has one WLC and couple of Wireless Access Points. This LAN network is connected to the internet through firewall and router. And there is a remote site over the internet which has another secondary WLC. Ca...

hi all,i need the following:-- check services status for WLC 3504 from GUI and CLI?- how to monitoring status for active services are down and get notify?

Hi to all, I need the secondary POE OUT Port on the C9124 in vlan 99 RAP switch config > trunk with native vlan 201 , which is my mgmt for my access points RAP config > see picture 1 MAP config > see picture 2 I can ping RAP and MAP.  VLAN Transparen...

Hi Is there any document that shows that WLC 9800-40 support wifi-6 and 6G band! I cant find that document

How many others find it frustrating that we don't have access to these sensors in Meraki? Seems like Cisco internal politics blocking access to valuable data to me…I'm hoping that if enough people engage with this they’ll at least see that it's not g...