07-23-2024 02:25 AM
Hello,
I have WLC 2504 and AP in Flexconnect mode, then i enabled netflow on the WLC and after some hours i can't see any netflow traffic.
Can i know i can't see any netflow traffic due the AP is in flexconnect mode?
Solved! Go to Solution.
07-23-2024 09:49 AM
The enhanced template is supported only on Cisco 3504, 5520, and 8540 controllers.
NetFlow is not supported on Cisco Virtual Wireless Controller (vWLC).
FlexConnect mode is not supported.
So 2504 is supported (on old template) but FlexConnect is not supported.
07-23-2024 02:32 AM
2504 WLC model not support netflow. Refer this document
HTH
Rasika
**** Pls rate all useful responses ***
07-23-2024 03:04 AM
Hello,
That document is official from cisco?
07-23-2024 09:51 AM
That document does not mention 2504 because 2504 and AireOS 8.5 are End of Support
07-23-2024 09:49 AM
The enhanced template is supported only on Cisco 3504, 5520, and 8540 controllers.
NetFlow is not supported on Cisco Virtual Wireless Controller (vWLC).
FlexConnect mode is not supported.
So 2504 is supported (on old template) but FlexConnect is not supported.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide