WLC2006 internal DHCP

[ptilling]

I am looking for help setting up the internal DHCP server. It keeps telling me the scope network and mask are incorrect. I have tried various setting and have looked around for a cfg example.

My MGMT int is 10.96.30.10

AP-MGR is 10.96.30.15

The scope and AP mgr interface can be any ip range, i do not need anything specific.

I have been trying 10.96.30.20-30

on network 10.96.30.10 / 255.255.0.0

Also does the 2006 support layer2?

[jackyoung]

I recommend to use external DHCP server, according to below link. There is DHCP relay issue if WLC as a DHCP server.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008070ba8f.shtml

Moreover, the 2006 supports LWAPP layer 3 only. The 44xx supports layer 2 & 3.

More info. from Q&A :

http://www.cisco.com/en/US/products/ps6366/products_qanda_item09186a008064a991.shtml

Hope this helps.

[ptilling]

thank you. i was putting the Netwrok address in incorrectly.