ASR 9903 HundredGigE 0/0/0/10 configuration

[j81edwards]

On the ASR 9903, there is a "breakout" port, for lack of a better word on my part, where you can use HundredGigE0/0/0/10 or TenGigE0/0/0/26-35.  At the moment, I can configure the Te interfaces, but am trying to configure Hu0/0/0/10 for service instead.  Hu0/0/0/10 is not showing up, and none of the 10G in that breakout are configured.  Can someone point me in the right direction.  My searches have come up empty, but I'm guess my context is incorrect.

Hu0/0/0/8 admin-down admin-down
Hu0/0/0/9 admin-down admin-down
Hu0/0/0/11 admin-down admin-down
Hu0/0/0/12 admin-down admin-down

Te0/0/0/26 admin-down admin-down
Te0/0/0/27 admin-down admin-down
Te0/0/0/28 admin-down admin-down
Te0/0/0/29 admin-down admin-down
Te0/0/0/30 admin-down admin-down
Te0/0/0/31 admin-down admin-down
Te0/0/0/32 admin-down admin-down
Te0/0/0/33 admin-down admin-down
Te0/0/0/34 admin-down admin-down
Te0/0/0/35 admin-down admin-down

[tkarnani · Accepted solution]

By default port 10,14 the 100G port is broken out to 10x10

port 10 = 16-25

port 14 = 26-35

to revert this back to 100G

use this command

  hw-module location 0/0/CPU0 bay 0 port <10,14> breakout 1xHundredGigE

[j81edwards]

Thank you for this information, I will verify in the morning!

[j81edwards]

I was able to complete this a few minutes ago.  This worked with one caveat, the reference ports were swapped.

port 10 = 26-35

port 14 = 16-25

I appreciate the assistance!