My NCS5501 device is affected in the bug CSCvk36151 and I found that this bug will fix on NCS5500 Series Version 6.6.25 to 7.5.1, but I don't see the 7.5.2 Version.So I would like to ask you that this bug (CSCvk36151) is fixed on 7.5.2 or not?
Forum Posts
We are trying to upgrade a NCS-5501 to 7.3.1 but it keeps failing saying not enough space but doing a show media shows that there is plenty of space in harddisk: Any suggestions?ov 14 13:54:27 Install operation 11 started by Cisco:install activate i...
Hello everyone,In the ASR 9000, what is the difference between the service edge optimized cards and the packet transport cards?It is true that QoS is the difference in general, for example, service edge optimization has advanced QoS features while pa...
HI all,I have faced MTU issue in MPLS L2 vfi tunnel. End Al2 vfi VLAN2559 manualvpn id 2559bridge-domain 2559mtu 9180neighbor 192.168.100.10 encapsulation mplsinterface BDI2559ip vrf forwarding ciscoip address 192.168.10.1 255.255.255.252End-Bl2 vfi ...
We've recently installed this line card into our chassis. Upon boot up the RSP comes online just fine however the line card never boots up. It get stuck at MBI-Booting, and then finally after several attempts drops the line card into rommon. Fur...
Hi Folks, What is the deep dive difference between the service edge optimized cards and the packet transport line cards in the ASR 9000?I know that QoS is the difference in general, for example, the service edge optimized has advanced QoS features wh...
Hi,I have a situation where "ibgp policy out enforce-modifications" is enabled globally to allow the next-hop to be changed for for prefixes towards specific iBGP peers.However, a different neighbor-group is used for basic route-reflection which is c...
Hello team,Looking for help on this. We have dual-homed setup with two local routers running ospf and isis upstream routers. If we have the following RPL policy to redistribute OSPF routes into ISIS, it seems like a bit much that all routes are dropp...
I'm able to get response to any destination when using ping, but got traceroute timeout on the ASR9K version 6.5.3. I cannot receive probe packets.I just want to understand is whether there is anything on the ASR9K could make traceroute not getting t...
Hi there,Can someone share a valid configuration guide to activate 40Gb interfaces in the A9K-4HG-FLEX-SE linecard?Thanks,
hello, I have router A9K with IOS XE, we i try to connect the client user (Windows) to the router as a PPPOE sessionthe first step (connecting) and second (authentication ) are fast, but step three takes a long time as the image I an attachmentmy rou...
Could anyone please advise the throughput for VTI / IPSec Tunnel interface for ASR9903 and ASR9904 routers.
Hello networkers, In MPLS L3VPN, can we advertise a route to eBGP neighbor only if there is at least one ISIS neighbor up ? (ISIS is the IGP and running in GRT). PE is an ASR 9010. The neighbor is dual-homed and the advertised route from PE to neighb...
Resolved! BGP VRF Route issue
HelloBoth CE received routers each other, but routes not reachable, they can access the next hop(PE) but in core routers somewhere the traffic getting blocked. Attached configs and topology
Hello,I'm preparing for NCS 5501-SE device upgrade from 7.0.2 to 7.5.2.There're one field notice which impacts my device: https://www.cisco.com/c/en/us/support/docs/field-notices/721/fn72108.htmlhttps://www.cisco.com/c/en/us/support/docs/field-notice...
