Hello Andy,
The node-id appears in the rack/slot/module notation, and the node-id components are as follows:
rack —In a single-shelf system the rack number is always “0.”
slot —Number of the physical slot in which the card is installed.
module —Subslot number of a system hardware component.
With SIP or MOD cards the subslot is used too.
Example:
RP/0/RSP1/CPU0:ariad#show plat
Thu Dec 13 21:23:42.927 CET
Node Type State Config State
-----------------------------------------------------------------------------
0/RSP0/CPU0 A9K-RSP440-SE(Standby) IOS XR RUN PWR,NSHUT,MON
0/RSP1/CPU0 A9K-RSP440-SE(Active) IOS XR RUN PWR,NSHUT,MON
0/0/CPU0 A9K-24x10GE-TR IOS XR RUN PWR,NSHUT,MON
0/1/CPU0 A9K-24x10GE-SE IOS XR RUN PWR,NSHUT,MON
0/2/CPU0 A9K-4T-B IOS XR RUN PWR,NSHUT,MON
0/3/CPU0 A9K-40GE-E UNPOWERED NPWR,NSHUT,MON
0/4/CPU0 A9K-MOD80-TR IOS XR RUN PWR,NSHUT,MON
0/4/0 A9K-MPA-4X10GE OK PWR,NSHUT,MON
0/4/1 A9K-MPA-20X1GE OK PWR,NSHUT,MON
0/5/CPU0 A9K-8T-L IOS XR RUN PWR,NSHUT,MON
0/6/CPU0 A9K-SIP-700 IOS XR RUN PWR,NSHUT,MON
0/6/0 SPA-2XOC48POS/RPR OK PWR,NSHUT,MON
0/6/1 SPA-OC192POS-XFP OK PWR,NSHUT,MON
0/6/2 SPA-1XCHSTM1/OC3 OK PWR,NSHUT,MON
0/7/CPU0 A9K-MOD80-SE IOS XR RUN PWR,NSHUT,MON
0/7/0 A9K-MPA-4X10GE OK PWR,NSHUT,MON
0/7/1 A9K-MPA-20X1GE OK PWR,NSHUT,MON
>Which way round are module 1 and 2? Is 1 on the left or right?
0 - left
1- right
> What is the port number for the first 10G interface, first line card first module
ports start from 0 and LC numbers are from 0 so that would be Te0/0/0/0
>What is the port number for the first Gigabit interface on a module fitted in module 2 on the first line card?
First LC is 0, 2nd module would 1 so that would be Gi0/0/1/0
Regards,
/A
