cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

1007
Views
0
Helpful
6
Replies

Can not enable ipv6 unicasting

I have cisco catalyst Model WS-C3560X-48, SW Version 15.0(1)SE2, SW Image C3560E-UNIVERSALK9-M

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 54    WS-C3560X-48       15.0(1)SE2            C3560E-UNIVERSALK9-M    

I want to enable ipv6 but I can't

Switch(config)#ip?

ip  ipc 

I search on cisco Feature Navigator it tell that this image can support ipv6.

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Can not enable ipv6 unicasting

6 REPLIES 6
Rising star

Can not enable ipv6 unicasting

Have you enabled 'ipv6 unicast-routing' enabled in the global config mode?

Can not enable ipv6 unicasting

What is the sdm template you are using?

Try to follow the steps here

http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst3750e_3560e/software/release/12.2_58_se/configuration/guide/swipv6.html#wp1059828

and report it back here if it fails.

HTH, Gustavo

Can not enable ipv6 unicasting

Thank you for your reply and I can not open the link because of Forbidden.

I type the command ipv6 unicasting but it can not.

Highlighted

Can not enable ipv6 unicasting

Can not enable ipv6 unicasting

Wonderful, after i configure command

Switch(config)#sdm prefer dual-ipv4-and-ipv6 default

i can use IPv6 features.

Thank, Andre.

Beginner

Re: Can not enable ipv6 unicasting

Why we need to configure this command for the switch?

Any special reason?

Sent from Cisco Technical Support iPad App

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here