cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1909
Views
0
Helpful
6
Replies

Can not enable ipv6 unicasting

I have cisco catalyst Model WS-C3560X-48, SW Version 15.0(1)SE2, SW Image C3560E-UNIVERSALK9-M

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 54    WS-C3560X-48       15.0(1)SE2            C3560E-UNIVERSALK9-M    

I want to enable ipv6 but I can't

Switch(config)#ip?

ip  ipc 

I search on cisco Feature Navigator it tell that this image can support ipv6.

1 Accepted Solution
6 Replies 6

Ivan Krimmel
Level 7
Level 7

Have you enabled 'ipv6 unicast-routing' enabled in the global config mode?

Andre Gustavo Albuquerque
Cisco Employee
Cisco Employee

What is the sdm template you are using?

Try to follow the steps here

http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst3750e_3560e/software/release/12.2_58_se/configuration/guide/swipv6.html#wp1059828

and report it back here if it fails.

HTH, Gustavo

Thank you for your reply and I can not open the link because of Forbidden.

I type the command ipv6 unicasting but it can not.

Wonderful, after i configure command

Switch(config)#sdm prefer dual-ipv4-and-ipv6 default

i can use IPv6 features.

Thank, Andre.

Why we need to configure this command for the switch?

Any special reason?

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: