can't cluster ASR9001

[zakaria-lebid]

Hi,

I want to cluster two ASR 9001,  but the command "control"  under "nv edge " command is not showing, it's showing only "Data" , so I can't add the chassis serials with the commands :

(admin config) # nv edge control serial <rack 0 serial> rack 0
(admin config) # nv edge control serial <rack 1 serial> rack 1

IOSXR 4.2.3

Please Advise,

Thanks.

[Rivalino Tamaela · Accepted solution]

duplicate post. Original is :

https://supportforums.cisco.com/discussion/12139306/cantt-cluster-asr9001

[zakaria-lebid]

Hi rtamaela,

I deleted the duplicate post, so please, can you advise on my previous request ?

Thanks,

[Muhammad Thanveer]

Dear Zakaria,

refer http://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r4-2/interfaces/configuration/guide/hc42asr9kbook/hc42clst.html#wp1011420

Hardware : Cisco ASR 9000 Series SPA Interface Processor-700 and Cisco ASR 9000 Enhanced Ethernet line cards are supported. Cisco ASR 9000 Enhanced Ethernet line card 10 GigE links are used as IRLs (inter-rack links).

Software : Cisco IOS XR Software Release 4.2.1 or later on Cisco ASR 9000 Series Router.

Also

A9K-NV-CLUSTR-LIC

nV Cluster license applicable per chassis

Please rate if the post is helpful

Thanveer

[zakaria-lebid]

Hello and thanks for your support,

I finally resolved the problem by upgrading from IOSXR 4.2.3 to 4.3.4.

Thanks,

Zakaria.